Please Keep in Mind the Principle of "five Don'ts" when Using High and Low Temperature Test Chambers

1. The high and low temperature test chamber should not be close to the heat source

When placing the high and low temperature test chamber, generally 60~70cm of use and maintenance space should be reserved on both sides, which can help the high and low temperature test chamber to dissipate heat. Also be careful not to put it together with some heating appliances, so as not to increase the power consumption of the high and low temperature test chamber.

2. The opening time of the high and low temperature test chamber should be short

In case of electricity, do not rush to open the door of the high and low temperature test chamber.

3. The ambient temperature difference of the high and low temperature test chamber should not be too large

The temperature difference in the use environment is too large, which will cause a large amount of water vapor to be generated in the high and low temperature test chamber during use. Over time, it will accelerate the corrosion of components, which can easily lead to damage to the high and low temperature test chamber.

4. Do not stop using the high and low temperature test chamber

In order to save electricity, many customers will put it in a "hibernation" state if the high and low temperature test chamber is temporarily unused. In fact, this is unscientific and may affect the service life of the high and low temperature test chamber, because the high and low temperature Most of the evaporators in the test chamber are made of aluminum, and the organic matter on the aluminum wall will mildew and deteriorate, corrode the aluminum plate, and damage the refrigeration system after it is stopped. Moreover, the plastic of the inner tank is more likely to age at room temperature than at low temperature. Therefore, it is best not to "shutdown" the high and low temperature test chamber.

If it is necessary to stop using the high and low temperature test chamber, it must be defrosted and cleaned, and placed in a ventilated and dry place to avoid direct sunlight. It is best to energize the high and low temperature test chamber once a month, and let the compressor run normally for half an hour to an hour before turning it off.

5. Do not switch frequently in the high and low temperature test chamber

In winter, the temperature of the general office is around 0 ~ 20°C, and the working temperature of the high and low temperature test chamber is relatively high. If it is switched on and off frequently, its internal components may be damaged during the transition between high and low temperatures.

Guangdong Yuanyao Test Equipment Co., Ltd. is an ISO9001:2015 certified manufacturer and trader specializing in the R&D and production of environmental test equipment such as environmental test chambers. After these years of rapid development, we have mature and advanced technology, an experienced technical team, professional and efficient service personnel, an independent research and development department, high-quality management and a complete after-sales service system. Welcome to consult.